The MARSHINE hereby reminds the maintenance team that when you use the 12000lbs Electric Powered 12V/24V Cable Winch Machine, you must follow the operation procedures strictly, so that to ensure the safe and efficient replacement of the wire rope. This winch has a single-rope tension of 2,700 kg and a double-rope tension of 5,400 kg, which can drive by a 12V or 24V motor and equipped with a 9.5 mm diameter, and a 24 m standard-length wire rope.
You need to disconnect the motor power before using the MARSHINE 12000lbs Electric Powered 12V/24V Cable Winch Machine, and then you also need to activate the automatic braking system to make sure the loads safety. Please put the worn steel wire rope back onto the drum while maintaining the tension, which make it cam prevent slack. When the steel wire rope is fully retracted, you can unlock the drum assembly and remove the annular end of the wire rope from its installation point. After that, you can connect a new steel wire rope with 9.5 mm diameter, and thread it through the winch guide and the drum groove, then release the wire rope slowly to apply the tension while the motor is reversing. When the steel wire rope is correctly wound in place, please lock the anchoring device, start the winch, and test its tension under a light load. Please pay attention to the steel wire rope length, the drum alignment, and the rated load, so that to ensure the MARSHINE 12000lbs Electric Powered 12V/24V Cable Winch Machine can maintain its 12,000-pound rated load capacity safely.
-
